Redneck Choppers, you probably have heard of them or a minimum of seen one of those choppers at a show. They are a complete known for their cheap costs, duct-tape engineering and a brand with a lot of humor! This Chopper is owned by Mike Marquart of South Dakota as Reps Ride and is constructed using Redneck Engineering’s GettinHigh frame.
The famous or not therefore Famous GettinHigh Chopper from Redneck Engineering. THis GettinHigh frames are well-liked frames for the past few years currently, they're affordable, durable and most importantly they look bad as hell!
Reps Ride is constructed on a Standard Gettinhigh Frame with a 48 degree Rake, eight? up and 5? out stretch. The Front Finish may be a Redneck Mid Duece (not sure if that is a mistake or intentional) Front end with ten over. The Handle Bars are Redneck Billy handle bars.
Reps Ride encompasses a Redneck King gas tank, and a custom built Redneck fender on the rear. This is sitting on a Weld Smoothie 18?8.5 rear wheel with a 250 tire and a CCI/West Coast a pair of?a pair of.5 front wheel. The wheels have HHI 4 front and rear brakes for stopping power.
All of this hardware is powered by a one hundred Revtec motor with a Andrews EV38 Cam and for delivery Mikuni HSR 42 Carb. The power is connected to a Revtec half dozen speed transmission with a BDL 3 inch primary. The exhaust may be a Grumpys One Off.
The Flame and Silver Paint is finished by Billy Hudson.
Mike’s Reps Ride is just a classic trying chopper, it really demonstrates what can be done with the Redneck Engineering Frame. Its High, its long and its overall a great looker!
No comments:
Post a Comment